Ballet pointe - TMT technology

Ballet pointe - TMT technology

TMT technology is a special technology that uses heat. Thanks to heating to a temperature of 60°C, the substance from which the tip is made is activated. It molds to your foot and after cooling, the toe hardens as you shape it. It will keep this shape throughout its lifetime. Thanks to this, the toes are comfortably molded to your foot and at the same time remain hard.

Mark the right and left tips. Blow-dry the tips from underneath the fingers for about 40 seconds. Twist the tip to blow dry the part where your thumb is for 20 seconds. Blow dry the top part of the box for 20 seconds and the part where the little finger is also for 20 seconds. Turn the toe back onto the sole and blow-dry the toes for another 20 seconds. Then put on the tip. Gently massage the box with your palms so that the toe is shaped as much as possible according to the foot. Grasp the heel with your hand and perform a relevé several times. Massage the box again and do some battemend tendu. Now the box is ready for cooling.
Place the tip in the fridge for about 5 minutes. Tips modified in this way last several times longer than traditional tips made of cardboard and plaster. If you need to repair the tip, repeat the procedure with the hair dryer and then cool the tip.

DO YOU NEED TO SOFTEN THE REINFORCEMENT ON THE SOLE? ARE THE TIPS RETURNING YOU AND TOO HARD? THAT'S IN THE PAST NOW. USING TMT TECHNOLOGY YOU NOW HAVE THE OPPORTUNITY TO CUSTOMIZE THE SHAPE OF THE SOLE TOO.

Mark approximately where you need the sole to be softer for a comfortable tiptoe. Blow-dry the designated area from the inside for about 60 seconds. Blow dry underneath for another 60 seconds. Repeat again from the inside for 60 seconds and from the bottom for 60 seconds. Gently break the tip with your fingers and place in the refrigerator.